Polaris ACE 900 2017 Service Manual page 328

FINAL DRIVE
11. Attach shock to A-arm with fastener. Torque lower
shock bolt to specification.
TORQUE
Shock Mounting Fastener:
42 ft-lbs (57 Nm)
12. Install the upper joint end into the front bearing
carrier.
13. Install a new upper ball joint pinch bolt
Torque to specification.
TORQUE
Ball Joint Pinch Bolts:
42 ft-lbs (57 Nm)
14. Install the fastener retaining the front stabilizer bar
link to the upper control arm. Torque fastener to
specification.
TORQUE
Stabilizer Link Fasteners:
42 ft-lbs (57 Nm)
15. Apply Anti-Seize to drive shaft axle splines.
7.38
16. Install front wheel hub assembly
and hand tighten the castle nut. Install washers with
domed side out.
e
and nut.
17. Install new brake caliper mounting bolts and torque to
specification.
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
18. Install the steering tie rod end
bearing carrier.
Refer to the photo below to ensure proper placement of
r
TORQUE
Front Caliper Mounting Bolts:
30 ft-lbs (54 Nm)
CAUTION
mounting bolts upon assembly.
NOTE
the tie rod end.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
t
, cone washers ,
y
onto the front