Polaris ACE 900 2017 Service Manual page 272

TRANSMISSION
12. Reinstall the starter motor. Torque the upper starter
motor bolt first and then the bottom bolt to
specification. Install the black ground wire and red
starter motor lead.
TORQUE
Starter Motor Bolts / Terminal Nuts:
7 ft-lbs (10 Nm)
13. Reconnect the shift lever cable on the transmission
shift lever. Torque nut to specification.
TORQUE
Shift Cable Fasteners:
13 ft-lbs (18 Nm)
14. Install the four fasteners retaining the intake manifold
to the engine and the one to retain the bottom of the
intake manifold to the transmission bracket.
TORQUE
Intake Manifold Mounting Fasteners:
To Engine: 17 ft-lb (23 Nm)
Lower: 22 ft-lb (30 Nm)
6.16
15. Install the two fuel rail mounting fasteners. Torque
fasteners to specification.
TORQUE
Fuel Rail Mounting Fasteners
5 ft-lb (7 Nm)
16. Reconnect and properly route the following electrical
components:
q
ETC
w
TMAP
e
Engine Temperature
Sensor
r
CPS
17. Install the three fasteners
the transmission switch and two fasteners
retaining the taillight harness wires to the frame.
18. Install the three harness clamps
manifold.
9929422 R02 - 2017-2019 ACE 900 Service Manual
t
Transmission Switch
y
Speed Sensor
Diff Relay (if equipped)
u
retaining the harness by
o
on the intake
© Copyright Polaris Industries Inc.
i