SAFETY PROCEDURES. separate from the normal system protection setting of Instantaneous. The Maintenance Mode is located in the EATON IS NOT LIABLE FOR THE MISAPPLICATION upper, white portion of the unit. OR MISINSTALLATION OF ITS PRODUCTS. 2.0 Maintenance Mode Settings The Maintenance Mode Settings (labeled R5, R4, R3, R2, R1) provide the Arc Flash Reduction setting.
Maintenance setting is armed. Refer to the ENABLE setting, the Maintenance Mode selection in diagram on page three for a wiring of this remote (blue the control screen of the Palm, Maintenance Mode is set. light) indicator. EATON CORPORATION Cutler-Hammer InformationSheets 70C1454H02 Courtesy of NationalSwitchgear.com...
Maintenance Mode setting. The LCD display, if powered, will indicate this with four dashes. The Maintenance setting, external wiring (if any) and tripping functionality should be periodically verified by primary or secondary injection current testing. EATON CORPORATION Cutler-Hammer Information Sheets 70C1454H02 Courtesy of NationalSwitchgear.com...
DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY The information recommendations, descriptions and safety notations in this document are based on Eaton’s experience and judgment and may not cover all contin- gencies. If further information is required an Eaton sales office should be consulted.