Futurecom PDR8000 Programming Manual page 66

Field Name
Tx Idle
Active
Packet Loss %
Network Health Measured Value
Good, Unreliable,
Unsuitable
Signal Quality
Signal's Quality
Idle
Metric
Active
SINAD Equivalent dB
RSSI
RSSI State Idle
Active
RSSI dBm
RSSI uV
RF Power
RF Power dBm
RF Power W
Squelch ON dB SINAD
Threshold
2022-08-25
Options / Description
Units
Specifies the Link Activity
Specifies percentage of
Packet loss over the wireline
interface
Specified the Link Quality of
the wireline interface
Idle: Below the SINAD
threshold.
Active: Above the SINAD
threshold.
SINAD value
Specifies the state of the
Receiver
Received signal strength in
dBm
Received signal strength in
uV
PDR8000 transmitting RF
power in dBm
PDR8000 transmitting RF
power in W
Sets the Squelch ON
Threshold.
®
PDR8000 Portable Digital Repeater Programming Guide
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Affects Analog Mode only.
Typical recommended setting
ON: 16dB SINAD.
If this field is temporarily modified in
Monitoring Window for "tuning" the
PDR, however leaving the Monitoring
Screen will result in reverting to the
previously programmed/saved values
Document 8K088X04 R5.01
Notes
Page 66 of 86