Mercedes-Benz Metris Operator's Manual page 86

Light and vision
84 84
Push in the catch spring of lamp housing
#
with a suitable object, e.g. a screwdriver, and
pry o lamp housing 1.
Turn socket 2 counter-clockwise and pull it
#
out of lamp housing 1.
Pull bulb 3 out of socket 2.
#
Push new bulb 3 into socket 2.
#
Screw socket 2 into lamp housing
#
turning it clockwise.
Place lamp housing 1 in position on the le
#
and engage it.
Signal and ambient lamp in t Signal and ambient lam p in the t
Push in the catch spring of the lamp housing
#
on the side of transparent lens
ble object, e.g. a screwdriver, and pry o the
lamp housing.
Turn socket 2 counter-clockwise and pull it
#
out of the lamp housing.
Pull the bulb out of socket 2.
#
#
#
#
W W indshield wipers
Switching t Switc
R R eq equir uirements:
R
1
1 by
1 g Windshield wipers o
he tailg ailgate ate
2 Ä Intermittent wiping, low
3 Å Intermittent wiping, high
4 ° Continuous wiping, slow
5 ¯ Continuous wiping, fast
#
#
#
3 with a suita-
Push the new bulb into socket 2.
Screw socket 2 into the lamp housing by
turning it clockwise.
Place the lamp housing in position at the side
of red lens 1 and engage it.
indshield wipers
hing the windshield wiper he windshield wipers on and s on and o o
ements:
The power supply has been switched on.
(low rain sensor sensitivity)
(high rain sensor sensitivity)
Turn the combination switch to the corre-
sponding position 1 – 5.
Single wipe: Single wipe: push the button on the combina-
tion switch in the direction of arrow 6.
T T o w o wash: ash: push the button on the combination
switch in the direction of arrow
the second point of resistance.
6 as far as