Mercedes-Benz Metris Operator's Manual page 202

200 Breakdown assistance
200
R R emo emoving t ving the v he vehicle t ehicle tool kit and jac ool kit and jack fr
st stor orag age tray e tray
Storage compartment with storage tray
Open clamping strap 5
#
by pulling it upwards at an angle from the stor-
age tray compartment.
Remove vehicle tool bag
#
storage tray compartment.
S S t t o o wing t wing the v he vehicle t ehicle tool kit and t ool kit and the jack
St Stor orag age com e compar partment wit tment with t h tool holder
Before stowing, wind the jack to the fully
#
closed position and place it so that the hand-
wheel is facing forwards and the plate is facing
inwards.
Place the jack and vehicle tool kit into the tool
#
holder.
Replace cover 3 of the tool holder.
#
Tighten clamping strap 4.
#
S S t t or orag age com e compar partment wit tment with st h stor orag age tray
Insert vehicle tool bag 7
#
partment of the storage tray.
Before stowing, wind jack
#
closed position and place it so that the hand
wheel is facing downwards and the plate is
facing inwards at an angle.
Insert jack 6 into the back compartment of
#
the storage tray.
Press jack 6 into the upper holder and fasten
#
clamping strap 5.
The jack is secured.
Closing t Closing the st he stor orag age com e compar partment tment
Put on cover 2.
#
Turn top rotary catch 1
#
and bottom rotary catch
Fold down the rear seat.
#
k from t om the he T T ool holder in t
R R emo
Tool holder in the cargo compartment on the right-
and remove jack 6
hand side of the vehicle (example: Cargo Van)
#
#
7 upwards from the
#
he jack
S S t t or oring t
ool holder
#
#
#
#
R R emo
e tray
into the front com-
6 to the fully
Holder for the jack in the cargo compartment on
the right-hand side of the vehicle (for example,
Cargo Van)
#
#
counter-clockwise
1 clockwise.
#
ool holder in the car he cargo com go compar partment
emoving t ving tools and t ools and the jack he jack
Remove clamping strap 2.
Remove cover 1 of the tool holder.
Carefully pull the vehicle tool kit and jack out
of the tool holder.
ing tools and t ools and the jack he jack
Before storing, wind the jack to the fully closed
position and place it so that the handwheel is
facing forwards and the plate is facing inwards.
Place the jack and vehicle tool kit into the tool
holder.
Install cover 1 of the tool holder.
Tighten clamping strap 2.
emoving t ving the jac he jack fr k from t om the t he tool holder ool holder
Remove clamping strap 1.
Pull jack 2 out of the upper holder and from
lower bracket 3.
The vehicle tool bag or tire-change tool kit is in
the seat base of the le front seat
( page 199).
/
tment