Eprom Operation; Table 5-6 Line In Selection - Analog Devices ADSP-21065L EZ-KIT Lite Manual

5.5.3.1 Line In Selection Jumpers
The EZ-KIT Lite uses a single stereo phone jack for line in and the microphone.
JP1 and JP2 are use to select between the two functions. The valid settings for
these jumpers are shown in Table 5-6.
JP1
Mic
Mic
Line
Line
5.5.3.2 AD1819 Codec Selection Jumper
SPORT1 is shared between the AD1819 and the EMAFE interface. Jumper JP3
disables the drive capability of the AD1819 on the SPORT1 lines, thereby
preventing contention between the two devices. When SPORT1 is not used by
the EMAFE device or an EMAFE device is not installed, JP3 should be
connected to ground, enabling the AD1819.
JP3
3.3V
CC
GND

5.6 EPROM Operation

The EPROM shipped with the EZ-KIT Lite is a 256K x 8 bit EPROM. The socket can
accommodate a 128K x 8, 256K x 8, 512K x 8, or a 1M x 8 bit EPROM. If any of these other
EPROMS are used, jumpers JP4 and JP5 should be changed to route the correct signals to the
EPROM. Settings for these jumpers are shown in Table 5-4.
www.BDTIC.com/ADI

Table 5-6 Line In Selection

JP2 Description
Mic Microphone In
Line INVALID
Mic INVALID
Line Line In
Table 5-7 AD1819 Codec Selection
Description
EMAFE selected (AD1819 disabled)
AD1819 selected (factory default)
47