Supermicro SuperServer SYS-E403-9D-16C-IPD2 User Manual page 144

SuperServer E403-9D-16C-IPD2/E403-9D-14CN-IPD2 User's Manual
6. After the process of BIOS recovery is completed, press any key to reboot the system.
7. Using a different system, extract the BIOS package into a bootable USB flash drive.
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the prompt.
Note: Do not interrupt this process until BIOS flashing is completed.
9. After seeing the message that the BIOS update is complete, unplug the AC power cable
from the power supply to clear the CMOS, and then plug the AC power cable in the
power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load default settings.
12. After loading default settings, press <F4> to save the settings and exit the BIOS Setup
utility.
144