CPI CLS Advance Operator's Manual page 41

CLS Advance
9 Technical characteristics
This chapter contains
• all relevant CLS data
• details of the power and PC interface
• reliability figures
• power supply requirements
• installation & service dimensions
• notes on environmental protection
9.1 Device data
Supply voltage 24 V DC ±5%
Power supply Input: 100–240 V AC
Output: 24 V DC ±10%
Current consumption Stand-by mode: 600 mA
Operating mode:
Max.:
Max. peak current:
Inrush current:
Make sure the CLS is powered using an appropriate power supply guaranteeing
the CLS is grounded to the mains
If not, the CLS is not protected against electromagnetic interferences and
damage, and proper operation cannot be ensured.
Regulations for grounding systems vary considerably among countries. Please
consider all relevant and applicable local regulations and directives.
Temperature range Operation:
Transport: -25 °C to 60 °C
Storage:
Cold start:
Temperature change Max. 0.2 °C/min
Rel. humidity Operation: 5–85%
Transport: 15–98%
Storage: -15–98% (in original packaging)
Condensation Not permitted
OM_CLS_-_EN_2-0
3 A
5 A
8 A
8 A
(cf. Chap. "9.4 Power supply requirements", p. 43)
5 °C to 55 °C
5 °C to 40 °C
0 °C
5–85% (unpacked)
Mechanical environmental conditions
(in original packaging)
(in original packaging)
Noise emission [ISO 7779:2010] Idle mode [bystander position]
[ISO 9296:1988-04] Operating mode [bystander position]
Average noise level during one operation cycle: 50 dB
Max. noise level during operation with coins:
Max. noise level during operation without coins: 72 dB
Interfaces Power:
For 24V-power supply unit permanently supplying at least 5 A
PC:
USB standard B
For pin assignment refer to
Coin input capacity Up to 50 €1-sized mixed coins at once
Coin acceptance Capacity to validate:
up to 24 different coin denominations
Capacity to sort:
up to 8 coin denominations, depending on sorting spiral and hoppers
installed
Capacity to process:
up to 50 coins at once
.
Diameter:
depends on sorting spiral installed,
EUR configuration: 16.25–25.75 mm
Max coin diameter 32.5mm
Thickness:
min. coin thickness 1.3mm, max. coin thickness 3.3mm
Speed:
Rate (first insertion): at least 95% with bulk insertions of 50 coins max.
Coin payout Capacity to collect:
up to 8 coin denominations in up to 8 single hoppers
approx. 335 €1-sized coins/single hopper, larger double and triple hoppers
available
For all relevant full and max. numbers of coins please refer to
Payout configuration & capacity", p. 16
Speed:
6 coins/s max.
Capacity to payout:
Return tray capacity of 50 €1-sized coins
Technical characteristics
Class Comment
Operation 3M2 Building without strong vibration
Transport
2M2 Any truck and trailer or carriage by rail/air
Storage Sensible vibrations & shocks due to machines
1M3
or passing vehicles
29 dB
79 dB
Chap. "9.3.1 USB port", p. 42
10 coins/s max., acceptance of first coin in less than 2 s
Chap. "5.10.1
41