Fig. 35: Removing A Hopper; Fig. 36: A Hopper's 3 Latching Points; Fig. 37: Front Hopper Bail Handles Tilted Correctly (Towards The Lid) - CPI CLS Advance Operator's Manual

Operation
7.5 Removing and reinstalling a coin hopper
We recommend you empty the hoppers before removing them. Otherwise
hopper coins tend to fall out of the hopper which could affect the hopper coin
counters and even damage the CLS.
Due to the locks on the front of the CLS, the both front coin hoppers can only be
removed after having removed the neighbor hoppers.
1
Open payout unit
(cf. Chap. "7.4 Opening and closing the coin payout unit", p. 29)
2
[Fig. 35/1] carefully pull out the hopper.
To reinsert the hopper:
3
Mind the color code on the hopper and above the hopper position (red hopper fits in red position).
4
Reinsert hopper into its dedicated position with its label pointing to the inside of the payout
unit and press on both front hopper corners (pointing to the return belt) until the hopper
engages in its three latching points [Fig. 36/2].
Attention!
Let the hopper engage correctly to ensure proper contact to the PCB and proper
operation.
5
Close payout unit again
(cf. Chap. "7.4 Opening and closing the coin payout unit", p. 29)
30
.
.

Fig. 35: Removing a hopper

Fig. 36: A hopper's 3 latching points

Fig. 37: Front hopper bail handles tilted correctly (towards the lid)

CLS Advance
OM_CLS_-_EN_2-0