CPI CLS Advance Operator's Manual page 4

List of figures
1 List of figures
Fig. 1: CLS front - Functional elements
Fig. 2: CLS rear - Functional elements
Fig. 3: Layer structure
Fig. 4: CLS with lid opened showing upper acceptance unit from the top
Fig. 5: CLS with upper acceptance unit opened showing upper acceptance unit from the bottom and
lower acceptance unit from the top
Fig. 6: CLS with lower acceptance unit opened showing payout unit
Fig. 7: Product label
Fig. 8: Detail: Interfaces, on-off switch and upper status illumination
Fig. 9: Detail: Upper and lower status Illumination
Fig. 10: Detail: Coin input funnel/dust tray and coin return tray
Fig. 11: Detail: Centrifuge, coin transport belt, coin validator and sorting spiral
Fig. 12: Detail: Coin hopper, Payout disc, return belt and tray, lower status illumination
Fig. 13: Euro configuration & capacity
Fig. 14: Detail: Coin return chute
Fig. 15: Detail: Rejector pin, coin return conveyor and tray
Fig. 16: Detail: Top key lock, push-button, pull handle
Fig. 17: Detail: Bottom lock and pull handle
Fig. 18: Coin input funnel providing three photoelectric sensors
Fig. 19: Centrifuge, coin validator providing several measurement sensors, coin rejector pin
and sorting spiral
Fig. 20: Sorting spiral providing sorting control sensors detecting coins falling into the hoppers
Fig. 21: Hopper providing coin ejector lever and payout control; coin return tray with full sensor
Fig. 23: Rear cutouts for fixing
Fig. 22: Bottom threaded inserts for fixing
Fig. 24: Detail: Interfaces, on-off switch and upper status illumination
Fig. 25: Switching CLS on/off
Fig. 26: Top key lock, push-button and pull handle
Fig. 27: Open lid
Fig. 28: Bayonet mount properly closed
Fig. 29: Coin validator arm lifted
Fig. 30: Disconnecting bayonet mount
Fig. 31: Bayonet mount disconnected
Fig. 32: Open acceptance unit
Fig. 33: Bottom key lock and pull handle
Fig. 34: Open payout unit
Fig. 35: Removing a hopper
Fig. 36: A hopper's 3 latching points
4
8 Fig. 37: Front hopper bail handles tilted correctly (towards the lid)
8 Fig. 38: Hopper filling via coin input funnel
9 Fig. 39: Direct hopper filling
10 Fig. 40: Raising coin return tray
Fig. 41: Bottom status illumination with coin return tray raised
10 Fig. 42: Loosening and removing funnel insert
11 Fig. 43: Reinserting funnel insert
12 Fig. 44: Surfaces to be cleaned, if necessary remove funnel insert
13 Fig. 45: Lifting the clip and folding down the dust tray for cleaning
14 Fig. 46: Unhinging the dust tray for cleaning
14 Fig. 47: In case of a coin jam: green coins into the hoppers, red coins to be taken out of the system
15 Fig. 48: Pulling coin(s) jammed (red) out of the payout slot
15 Fig. 49: Checking payout slot protective flap for easy movement
16 Fig. 50: Removing hopper bowl and payout disk
16 Fig. 51: Reinstalling hopper bowl
17 Fig. 52: Detail: Upper and lower status illumination
18
18
19
20
21
22
23
23
24
25
26
26
27
27
28
28
28
29
29
30
30
CLS Advance
30
32
32
33
33
35
35
36
37
37
38
39
39
40
40
46
OM_CLS_-_EN_2-0