Fig. 33: Bottom Key Lock And Pull Handle; Fig. 34: Open Payout Unit - CPI CLS Advance Operator's Manual

CLS Advance
7.4 Opening and closing the coin payout unit
The coin payout unit can be opened and closed using the key for the lower lock [Fig. 33/1] to
eliminate coin jamming, for instance, or to service the CLS:
Hand over the key to open the payout unit only to personnel allowed to access
the cash.
Though the CLS stops running when the payout unit is opened, you should always
wait until a transaction has been finished before you open the payout unit to not
affect the coin counters.
To open the payout unit the lid must be closed
1
If necessary, wait until a transaction has been finished and switch the CLS off
Switching the CLS on/off", p. 25)
2
Insert the key in the lower lock [Fig. 33/1] and turn it counter-clockwise as far as it will go.
3
Open the payout unit by the handle [Fig. 33/2] as far as it will go.
Opening the unit is supported by the gas springs.
Do not unlock the lid and press the push-button to open the lid when the payout
unit is open. This unlatches the coin acceptance unit and may damage the
device or result in injuries.
To close the payout unit again:
4
Close the CLS again.
5
Turn the key clockwise as far as it will go and pull it out of the lock.
6
Switch the CLS on again
OM_CLS_-_EN_2-0
(cf. Chap. "7.2 Opening and closing the CLS lid", p. 26)
.
.
(cf. Chap. "7.1 Switching the CLS on/off", p. 25)
OPEN
:
(cf. Chap. "7.1
CLOSE

Fig. 33: Bottom key lock and pull handle

Fig. 34: Open payout unit

Operation
29