Fig. 42: Loosening And Removing Funnel Insert; Fig. 43: Reinserting Funnel Insert - CPI CLS Advance Operator's Manual

CLS Advance
8.3 Removing and reinserting funnel insert
Cleaning the coin input funnel requires the input funnel insert to be removed:
1
Open the CLS lid
(cf. Chap. "7.2 Opening and closing the CLS lid", p. 26)
2
Carefully fold down the dust tray and clean it if necessary
.
p. 37)
3
Carefully put the slotted screw driver through the bottom center hole of the input funnel, pry
funnel insert loose [Fig. 42/A] and remove it upwards [Fig. 42/B].
4
Close dust tray
(cf. Chap. "8.4.2 Emptying the dust tray", p. 37)
again.
the CLS lid", p. 26)
For reinsertion of the funnel insert:
5
Insert funnel insert by its two snap-in latches into the input funnel's outer holes of the center
row [Fig. 43/A] and press insert down into the input funnel for tight fit of the insert [Fig. 43/B].

Fig. 42: Loosening and removing funnel insert

OM_CLS_-_EN_2-0
.
(cf. Chap. "8.4.2 Emptying the dust tray",
and lid
(cf. Chap. "7.2 Opening and closing
A B

Fig. 43: Reinserting funnel insert

A
Service
B
35