CPI CLS Advance Operator's Manual page 34

Service
8.2.2 Emptying the hoppers manually
Due to the locks on the front of the CLS, the both front coin hoppers can only be
removed after having removed the neighbor hoppers.
1
Open payout unit
(cf. Chap. "7.4 Opening and closing the coin payout unit", p. 29)
2
Carefully pull out the hopper to be emptied.
Exercise care when removing full coin hoppers. To guarantee proper operation
of the CLS the coins must not fall into the device.
3
Empty hopper.
4
Repeat steps 2 & 3 for all hoppers to be emptied.
5
Mind the color code on the hopper and above the hopper position (red hopper fits in red position).
6
Reinsert hopper(s) into its dedicated position(s) with its label pointing to the inside of the
payout unit and press on both front hopper corners (pointing to the return belt) until the hopper
engages in its three latching points [Fig. 36/2].
7
Close payout unit again
(cf. Chap. "7.4 Opening and closing the coin payout unit", p. 29)
8
Reset the hoppers' coin counters in control software.
Attention!
Let the hopper engage correctly to ensure proper contact to the PCB and proper
operation.
34
.
.
CLS Advance
OM_CLS_-_EN_2-0