Registering The Card Ids - Canon imageRUNNER 1750 Series Service Manual

Registering the Card IDs

After installing the Card Reader, register the card numbers to be used in the service mode of
the host machine.
If they are not registered, cards will not be recognized when inserted.
1) Plug the power cord into the outlet.
2) Turn on the main power switch.
3) Enter service mode.
4) Get in Service Mode (# ACC> CARD) and enter the card number to use (1 to 2000).
• Enter the smallest card number of the cards used by the user.
• From the entered number, up to 1000 cards can be used.
5) Turn main power switch off and on again.
6) Press Additional Functions
to enter user mode.
7) Select System Settings > Department ID Management > ON, and perform various settings.
(See User Manual CD-ROM > System Setings Guide > Chapter 1 Before You Start > Setting
System Management Mode)
8) Insert the card with registered valid number to check it's at standby state.
9
Installation > Copy Card Reader-F1 > Registering the Card IDs
9 Installation > Copy Card Reader-F1 > Registering the Card IDs
9-21
9-21