4
Disassembly/Assembly > Image Formation System > Removing the Main Drive Unit > Procedure
Removing the Main Drive Unit
■ Preparation
1) Remove the Rear Cover.(Refer to page 4-24)
2) Remove the Right Rear Cover.(Refer to page 4-26)
3) Remove the Waste Toner Container.(Refer to page 4-67)
4) Remove the Drum Unit.(Refer to page 4-68)
■ Procedure
1) Disconnect the 2 Connectors [1] and remove the Wire Saddle [2].
x2
2) Disconnect the Relay Connector [2] from the hole [1] of the plate.
• 1 Connector [3]
[3]
4
Disassembly/Assembly > Image Formation System > Removing the Main Drive Unit > Procedure
[2]
[1]
F-4-140
[1]
[2]
F-4-141
3) Move the Harness Guide [1].
• 1 Boss [2]
• 2 Hooks [3]
• 1 Connector [4]
[1]
[2]
[3]
4) Remove the Registration Clutch [1].
• 1 Connector [2]
• Guide [A]
• 1 E-ring [3]
[A]
[2]
4-73
[4]
[1]
F-4-142
[1]
[3]
F-4-143
4-73