Details Of Service Mode; Sssw; Sssw Composition; Details - Canon imageRUNNER 1750 Series Service Manual

Details of Service Mode

#SSSW

■ SSSW Composition

NOTE:
This document describes the default settings for the system for USA.
The default settings used in the service mode vary depending on the shipping
destination and model.
No. Initial setting
SW01 00000000 error/copy control
SW02 00010000 network connection setting
SW03 00000000 echo remedy setting
SW04 00000000 communication fault remedy setting
SW05 00000000 standard function (DIS signal) setting
SW06 10010000 read condition setting
SW7-SW11 not used
SW12 00000010 page timer setting
SW13 00000000 meter/inch resolution setting
SW14 00000001 inch/meter resolution setting
SW15 00000000 dial-in FAX/TEL switch-over function
SW16-SW17 not used
SW18 00000000 remedies for communication faults (2)
SW19-21 not used
SW22 00000000 fault remedy setting
SW23-24 not used
SW25 00000000 report indication resolution setting
SW26-27 not used
SW28 00000000 V.8/V.34 protocol settings
SW29 not used
SW30 00000000 Assigning a New Dial Tone Detection Method
SW31 not used
SW32 00000000 not used
SW33 00000000 counter function settings
SW34 00000011 waste toner full display setting
SW35 00001000 e-RDS function settings
SW36 00000000 Settings to disable auSend
SW37 11111111 Display settings for initialization menu after parts replacement 1
SW38 - SW50 not used
8
Service Mode > Details of Service Mode > #SSSW > Details
Function
T-8-1
8 Service Mode > Details of Service Mode > #SSSW > Details

■ Details

● SSSW-SW01
List of Functions
Bit Function
0 service error code
1 not used
2 not used
3 not used
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 0
Selects whether or not service error codes are output. When output is selected, service error
codes is report.
● SSSW-SW02
List of Functions
Bit Function
0 not used
1 not used
2 not used
3 not used
4 V34 CCRTN OFF
5 not used
6 not used
7 F network silent termination service
Detailed Discussions of Bit 4
V.34 control channel retrain can be disabled. When "1" is set, control channel retrain is not
started by the own machine.
Detailed Discussions of Bit 7
Select whether or not the machine is compatible with the F network (facsimile communication
network) silent termination service. When "Compatible" is selected, the machine automatically
receives a fax upon detection of the FC signal (1300 Hz tonal signal) without generating a
ringtone.
8-5
1 0
output not output
- -
- -
- -
- -
- -
- -
- -
T-8-2
1 0
- -
- -
- -
- -
Disable Not disable
- -
- -
Compatible Not compatible
T-8-3
8-5