Starting The Zt-2000 I/O Device; Communications Testing - ICP DAS USA ZT-2017 User Manual

3.3 Starting the ZT-2000 I/O Device

As the ZigBee network is controlled by the ZigBee Coordinator, the
ZT-2550/ZT-2570 (ZigBee Coordinator) must be configured first. Refer to the
documents shown below for full details of how to configure these devices.
Once configuration of the ZigBee Coordinator has been completed, set the "Pan
ID" and "RF Channel" values for the ZT-2000 I/O device to the same values as
the network, and then reboot the device. The module will automatically start to
function on the ZigBee network using the default protocol.
※ Documents
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/document/zt-255x/
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/document/zt-257x/
Configuration Utility
※
Coordinator)
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/utility/

3.4 Communications Testing

Once the ZT-2000 I/O device has joined the ZigBee network, the signal quality
can be confirmed by monitoring the status of the ZigBee Net LED indicators. If
the LED indicator shows a steady light, communication with the ZT-2000 I/O
device has been successfully established for data acquisition and control.
ICP DAS, ZT-2017 and ZT-2017C AI Series User Manual, Version 1.0.1
Copyright © 2012 by ICP DAS Co., Ltd. All Rights Reserved.
(Used to configure the ZT-2000 I/O device
Page 21