10-channel universal voltage input & current input, thermocouple input module (8 pages)
Summary of Contents for ICP DAS USA M-7067
Page 1
1. Introduction The M-7067 device is a network data acquisition and control module that support Modbus RTU. They can be remotely controlled using a set of commands called DCON protocol. With the Modbus RTU protocol, it can easily communicate with most popular SCADA/ HMI software and PLCs.
。 Module Address: 01 。 DIO Type: Type 40 。 Baud Rate: 9600 bps 。 Checksum disabled M-7067 7 Ch Form A Relay Output DAQ Module - QuickStart (Apr/2018) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
Page 3
3. Connect the module to the power supply using the +Vs and GND terminals. Note that the voltage supplied should be in the range of +10 to +30V DC. M-7067 7 Ch Form A Relay Output DAQ Module - QuickStart (Apr/2018) ICP DAS USA, Inc.
Page 4
The default settings for the module can be found in Section 3. Click OK after selecting the COM port setting. M-7067 7 Ch Form A Relay Output DAQ Module - QuickStart (Apr/2018) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 5
DCON Utility Pro supports DCON and Modbus protocol for all ICPDAS and the others modules. 6. Configuration I/O module setting on PC M-7067 7 Ch Form A Relay Output DAQ Module - QuickStart (Apr/2018) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 6
8. If user doesn’t know command, user can select Address and ID, it will show some refer commands as below. User can select necessary command to test or debug modules. M-7067 7 Ch Form A Relay Output DAQ Module - QuickStart (Apr/2018) ICP DAS USA, Inc. | www.icpdas-usa.com...