Aam - ICP DAS USA ZT-2017 User Manual

6.2.15 $AAM

Description
This command is used to read the name of a specified module.
Syntax
$AAM[CHECKSUM](CR)
$ Delimiter character
AA The address of the module to be read in hexadecimal format (00 to FF)
M The command to read the name of the module
Response
Valid Command
Invalid Command
! Delimiter character to indicate a valid command
? Delimiter character to indicate an invalid command
AA The address of the responding module in hexadecimal format (00 to FF)
(Data) The name of the module as a string value
There will be no response if the command syntax is incorrect, there is a
communication error, or there is no module with the specified address.
Example
Command $03M
Response !03ZT-2017
Reads the name of module 03 and returns a response indicating that the
command was successful, and that the name of the module is "ZT-2017".
※Related Commands: ~AAO(Name)
ICP DAS, ZT-2017 and ZT-2017C AI Series User Manual, Version 1.0.1
Copyright © 2012 by ICP DAS Co., Ltd. All Rights Reserved.
!AA(Data)[CHECKSUM](CR)
?AA[CHECKSUM](CR)
Page 58