Modbus Address Mapping - ICP DAS USA ZT-2017 User Manual

6.3.1

Modbus Address Mapping

Address Description
00259 The filter settings.
0: 60Hz rejection
1: 50Hz rejection
00260 The Modbus Host Watchdog mode:
0: The same as I-7000 series modules
1: The AO and DO commands can be used to
clear the status of the Host Watchdog timeout
00261 Enables or disabsle the Host Watchdog:
0: Disable
1: Enable
00269 The Modbus Data Format:
0: Hexadecimal
1: Engineering Units
00270 The Host Watchdog timeout status. Write 1 to
clear.
00272 The factory calibration parameters. Write 1 to
load.
00273 The Reset status:
0: This is not the first time the module has been
read after being powered on
1: This is the first time the module has been read
after being powered on
00280 The high latch values for all channels. Write 1 to
clear.
00281 The low latch values for all channels. Write 1 to
clear.
00513 ~ The high latch values for channels 0 to 7. Write 1
00520 to clear.
00545 ~ The low latch values for channels 0 to 7. Write 1
00552 to clear.
00577 ~ Enables or disables the high alarm for channels 0
ICP DAS, ZT-2017 and ZT-2017C AI Series User Manual, Version 1.0.1
Copyright © 2012 by ICP DAS Co., Ltd. All Rights Reserved.
Address Mapping
Attribute
R/W
R/W
R/W
R/W
W
W
R
W
W
W
W
R/W
Page 105