Maintenance Timer; Setting Maintenance Timer - Optex SC-U1 Operation Manual

uMaintenance Timer
A maintenance timer can be set to an arbitrary cycle and notified when the set cycle has
elapsed.
This is used for notification of sensor maintenance, replacement of consumables, and
overhaul timing.
When the maintenance timer has expired, "MAINT" is
displayed on the measurement value display of the sensor.
Notifications can be checked by the relay output
("Maintenance output setting" P.46) and the cloud server (when connected to the GW).
For more information about checking notifications on the cloud server, refer to the cloud
server's help.
●Setting maintenance timer
Set the maintenance timer.
The setting range is shown below.
Output Item
Maintenance OFF
Timer 7 to 1095 days (by 1 day)
On the sensor selection display, select a
1
sensor to set using
Maintenance timer setting must be set for each sensor.
If [ALL] is selected, the setting is not available.
2
Select [Maintenance Timer] using
and press
70
Setting range
, and press
.
Factory default setting
OFF
.
Output
item
Sensor channel
,
Sensor
model