Cleaning Interval (Relay) - Optex SC-U1 Operation Manual

uCleaning Interval (Relay)
Set the time interval between cleaning actions.
The settings are to activate the cleaning device using a relay output ("Cleaning output setting" P.47).
The setting range is shown below.
Output Item

Cleaning Interval (Relay)

[Cleaning Interval-RLY]
On the sensor selection display, select a
1
sensor to set using
The cleaning menu is displayed.
Cleaning interval (relay) setting must be set for each
sensor.
If [ALL] is selected, the setting is not available.
2
Select [Cleaning Interval-RLY] using
and press
3
Select a digit by
• When the value is 10, press
• When [OFF] is set, press
interval (relay) input display.
When a value outside the set range is entered, a short beep sounds.
Press
By pressing
The display returns to the cleaning menu.
76
Setting range
OFF (No cleaning)
10 to 1440 minutes (by 10 minutes)
, and press
.
and value by
to select [OFF].
to display the cleaning
simultaneously while entering a value to reset to the factory default setting.
or , the value returns to the one before changing it.
Factory default setting
30 minutes
.
Output item Sensor model
Sensor channel
,
, and press .