Table of Contents
Advertisement
4-20 mA test mode
A test output of 4, 12, and 20 mA can be performed to check the signal output status to a
recorder (data logger).
On the channel selection display,
1
press
to switch between pages.
2
Use
and press
The 4-20 mA test mode menu is displayed.
3
Select a channel to set using
electrical current value to output using
.
The selected current value is continuously output
from the selected channel.
In the initial status, ALL (all channels) and OFF (no
output) are selected.
When selected as shown to the right, 12 mA is
output from channel 2.
4
To end the test, press
to select [4-20 mA Test mode]
.
.
Sensor channel
and
Output item
37
Advertisement
Table of Contents
