Cleaning Activation - Optex SC-U1 Operation Manual

Refer to "Cleaning output setting" P.47 to set [Cleaning] of the sensor
4
for which cleaning interval is set in the output item of relay output.
uCleaning Activation
Set the time period for cleaning.
The settings are to activate the cleaning device using a relay output ("Cleaning output setting"
P.47).
The measurement value is retained (held) during cleaning.
The setting range is shown below.
Output Item

Cleaning Activation

On the sensor selection display, select a
1
sensor to set using
The cleaning menu is displayed.
Cleaning activation setting must be set for each
sensor.
It cannot be set when [ALL] is selected.
2
Select [Cleaning Activation] using
and press
3
Select a digit by
and press
When a value outside the set range is entered, a short
beep sounds.
Press
to reset to the factory default setting.
By pressing
before changing it.
The display returns to the cleaning menu.
Setting range
10 to 120 seconds (by 10 seconds) 30 seconds
, and press
.
and value by
.
simultaneously while entering a value
or , the value returns to the one
Factory default setting
.
Output item Sensor model
Sensor channel
,
,
77