Hysteresis - Optex SC-U1 Operation Manual

●Hysteresis
Set the hysteresis to cancel the alarm output.
In the setting item selection menu, select
1
[Hysteresis] using
2
Select a digit by
, and press
• If the alarm trigger is set as High Alarm, set a value
lower than the active level.
• If the alarm trigger is set as Low Alarm, set a value
lower than the active level.
When a value outside the set range is entered, a short
beep sounds. The setting range varies depending
on the measurement item. Refer to each sensor's
instruction manual.
Press
to reset to the factory default setting.
By pressing
before changing it.
The indication returns to the setting item selection menu.
, and press
and value by
.
simultaneously while entering a value
or , the value returns to the one
.
43