Manual Cleaning - Optex SC-U1 Operation Manual

Item
Shown below are the settings to activate the cleaning device using a relay output
("Cleaning output setting" P.47).
Cleaning
Interval (Relay)
Cleaning
Activation
Post-cleaning
Standby
The settings work as shown below:
Cleaning
activation
Cleaning
Cleaning
device
Measurement
Measurement value hold
value
uManual Cleaning
The wiper and cleaning device can be manually activated. The cleaning device can be
activated only if the cleaning output has been set using relay output.
The measurement value of the target sensor is retained (held) during cleaning.
On the sensor selection display, select a
1
sensor to set using
The cleaning menu is displayed.
By selecting [ALL], all of the connected sensors can
be selected.
2
Select [MANUAL CLEANING] using
and press
The cleaning device is activated and the display
returns to the measurement value display.
The sensor under cleaning shows "CLEAN" on the
measurement value display.
In addition, "C" is displayed in the sensor selection
display.
74
Set the time interval between cleaning actions.
Set the time period for cleaning.
The last measurement value is retained (held) during cleaning.
Set the standby time after cleaning.
The measurement value is retained (held) during post-
cleaning standby.
Cleaning interval (relay)
Post-cleaning
standby
Normal measurement
, and press
.
Description
Cleaning interval (relay)
Post-cleaning
Cleaning
activation standby
Cleaning
Measurement value hold
.
,
Refer to
P.76
P.77
P.78
Normal measurement
Output item Sensor model
Sensor channel