Relay Test Mode - Optex SC-U1 Operation Manual

Relay test mode

Switch the relay ON/OFF and check the output status to the control panel.
On the channel selection display,
1
press to switch between pages.
2
Select [Relay Test Mode], and press
The relay test mode menu is displayed.
3
Select a channel to set using
and output ON/OFF using
While [ON] is selected, relay output will continue
from the selected channel.
In the initial status, ALL (all channels) and OFF (no
output) are selected.
When selected as shown to the right, relay output is
done from channel 2.
4
To end the test, press
.
.
.
49