Table of Contents
Advertisement
Do not apply strong shock or
excessive force to the Transmitter.
It may cause failure.
Do not install in places exposed to
direct sunlight or poorly ventilated
areas.
Use the supplied cable gland for the
Transmitter. When connecting piping
directly to the Transmitter, take
measures to prevent corrosive gas
such as chlorine gas from entering
the Transmitter through piping.
Do not touch electrical parts or the
board.
Unit only suitable installed in control panel.
To acquire proper measurement values
To clean the Transmitter,
gently wipe it with
a clean, soft cloth
containing diluted
neutral detergent, and
then wipe off moisture
with a dry clean soft
cloth. Do not wipe with
an organic solvent. It
may cause failure.
Use the included transmitter
mounting bracket for installation.
Do not bind the signal output cable
and the power cable together or
place them in the same cable gland.
Remove the protective film from the
display before use.
Paint
thinner
9
Advertisement
Table of Contents
