Response Time - Optex SC-U1 Operation Manual

uResponse Time
Set a signal output response time.
A measurement value is calculated using moving average of the time period configured by
the signal output response time. For example, if the sensor measures values every 5 seconds
and the signal output response time is set to 50 seconds, which is 5 seconds × 10 times, the
moving average of 10 times measurement is calculated and used as the measurement value.
The setting range is shown below.
Response 5 to 600 seconds (by 5 seconds)
Time
Shown below is an example of configuring 10 seconds as the signal response time.
On the sensor selection display, select a
1
sensor to set using
The sensor setting menu is displayed.
2
Select [Response Time] using
and press
The current setting value is displayed.
3
Select a digit by
, and type in a value.
In this example, "10" is typed in to set as 10 seconds.
When a value outside the set range is entered, a short beep sounds.
Press
setting.
By pressing
4
Press .
The setting is complete and the display returns to the sensor setting menu.
Setting range
, and press
.
and value by
simultaneously while entering a value to reset to the factory default
or , the value returns to the one before changing it.
Factory default setting
5 seconds
.
Measurement
item
Sensor channel
,
Sensor
model
25