Table of Contents
Advertisement
uPost-cleaning Standby
Set the standby time after cleaning.
The settings are to activate the cleaning device using a relay output ("Cleaning output setting"
P.47).
The measurement value is retained (held) during post-cleaning standby.
The setting range is shown below.
Item
Post-cleaning Standby
On the sensor selection display, select a
1
sensor to set using
The cleaning menu is displayed.
Post-cleaning standby setting must be set for each
sensor.
If [ALL] is selected, the setting is not available.
2
Select [Post-cleaning Standby] using
and press
3
Select a digit by
, and press
When a value outside the set range is entered, a short
beep sounds.
Press
to reset to the factory default setting.
By pressing
before changing it.
The display returns to the cleaning menu.
78
Setting range
10 to 180 seconds (by 10 seconds) 30 seconds
, and press
.
and value by
.
simultaneously while entering a value
or
, the value returns to the one
Factory default setting
.
Output item Sensor model
Sensor channel
,
Advertisement
Table of Contents
