Optex Redwall Wire-Free WF-100DT User Manual

WF-100DT Digital Transmitter
© Optex (Europe) Ltd. 2007
Every effort has been made to ensure that the contents of this book are correct. However,
neither the authors nor Optex (Europe) Ltd accept any liability for loss or damage caused
or alleged to be caused directly or indirectly by this book. The contents of this book are
subject to change without notice.
Printed and published in the U.K.
The WF-100DT Digital Transmitter should be programmed to the WF-100CU Control Unit
before commencing the installation. Refer to the Redwall Wire-Free 'Installation &
Programming Guide' supplied with the WF-100CU Control Unit.
Radio Section
Power Requirements
Radio Signalling
Environmental Class
Ingress Protection
Dimensions
Weight
Issue 1
Redwall Wire-Free
User Guide
1. INSTALLATION
2. TECHNICAL SPECIFICATION
Operating frequency 868.6625MHz at 20KHz bandwidth.
2 x Duracell MN1300 (not supplied). Typically two year battery life.
Alarm, tamper, supervision and low battery.
IV Outdoor – General.
IP64.
122 x 120 x 85 mm. H x W x D.
475g.
- 1 - 400001