Trigger; Active Level - Optex SC-U1 Operation Manual

●Trigger
For alarm output, set High Alarm (upper limit trigger) or Low Alarm (lower limit trigger).
In the setting item selection menu, select
1
[Trigger] using
Select [High Alarm] or [Low Alarm] using
2
, and press
• High Alarm (upper limit trigger)
Alarm condition is met when a measurement value
exceeds the active level
• Low Alarm (lower limit trigger)
Alarm condition is met when a measurement value
falls under the active level
The display returns to the setting item selection menu.
●Active Level
Set a measurement value to activate the On delay.
In the setting item selection menu,
1
select [Active Level] using
and press
2
Select a digit by
, and press
When a value outside the set range is entered, a short
beep sounds. The setting range varies depending
on the measurement item. Refer to each sensor's
instruction manual.
Press
to reset to the factory default setting.
By pressing
before changing it.
The display returns to the setting item selection menu.
42
, and press
.
.
and value by
.
simultaneously while entering a value
or , the value returns to the one
.
,