Maintenance Output Setting - Optex SC-U1 Operation Manual

uMaintenance output setting
Set a maintenance timer for any cycle ("Maintenance Timer" P.70) to notify the user when
the set cycle has elapsed.
This is used for notification of sensor maintenance, replacement of consumables, and
overhaul timing.
Notifications can be checked by the relay output and the cloud server (when connected to the GW).
For more information about checking notifications on the cloud server, refer to the cloud
server's help.
To select the maintenance output as a relay output item, refer to "Maintenance Timer"
Caution
P.70 to configure the output cycle (days) before configuring the following setting.
After setting, the maintenance output can be selected as an output item of the relay.
On the channel selection display, switch
1
between pages using
channel to set using
The setting item selection menu is displayed and the
current setting of the selected channel is displayed.
2
Select [Output Item] using
and press
The current setting value is displayed.
3
Switch between pages using
select [Maint.] of a sensor channel
to set maintenance output using
and press
If output is unnecessary, select [OFF]
and press
Available display items depend on an installed sensor.
The set sensor channel and [Maint.] are displayed in
[Output Item].
46
, select a
, and press
.
.
.
.
,
,
,
Output item
Sensor channel
Output Sensor
item model
Sensor channel