System Re-Initialization - NEC IntraMail 4 System Manual

System Re-initialization

System Re-initialization
Description
Initializing the telephone system automatically initializes all IntraMail programming. You may want to do
this if the site requirements significantly change and it is easier to start over from default than remove all
your custom programming. Re-initializing IntraMail returns all programmed options to their default values.
To initialize (erase) Subscriber Mailbox Security Codes and all recordings, use a System Administrator
Mailbox.
Related Features
System Administrator (page 171)
The System Administrator can delete Subscriber Mailbox security codes as well as IntraMail recorded
messages.
Programming
Step 1
Step 2
Operation
N/A
174 ◆ Chapter 2: Features
Re-initializing the telephone system returns all programmed options to
their factory set (default) values. Any site specific programming
you have done will be erased following re-initialization.
To re-initialize the telephone system data base:
Press ICM and dial #*#* + 372000 + HOLD .
1.1
Dial 9999 + HOLD .
1.2
Dial Y (9) + HOLD .
1.3
- The telephone system data base initializes.
- To cancel initialization, dial N (6) + HOLD instead.
To erase recorded messages and Subscriber Mailbox Security Codes:
See System Administrator on page 171.
2.1
- The recorded messages include:
Instruction Menus
Announcement Mailbox messages
Messages left in a Subscriber Mailbox
Subscriber Mailbox greetings
Subscriber Mailbox names
IntraMail System Guide