NEC IntraMail 4 System Manual page 80

Directory Dialing
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
70 ◆ Chapter 2: Features
To change the amount of time Directory Dialing callers have to dial letters:
8006 - IntraMail Routing Mailboxes: Time Limit for Dialing Commands on page 231.
6.1
- Enter the new timeout duration (0-99 seconds).
- If the caller waits too long to dial, the Directory Dialing Message repeats.
✔
By default, Directory Dialing callers have 5 seconds to dial letters.
To record a Directory Dialing Message:
See Operation below.
7.1
- The Directory Dialing Message is the Instruction Menu for the Routing Mailbox pro-
grammed as a Directory Dialing Mailbox.
✔
By default (without a custom message recorded), the Directory Dialing Message is,
"Please enter one or more letters of the person's name, then press the pound key."
8004 - IntraMail System Options: Non-Subscriber Message Length on page 213.
7.2
- This option sets the maximum message length (1-4095 seconds) for Instruction Menus.
✔
By default, this option is 120 seconds.
Enable or disable the ability of the Directory Dialing Mailbox to detect and route incoming
faxes.
8006 - IntraMail Routing Mailboxes: Fax Detection on page 231.
8.1
- Enter Y to enable Fax Detection; N to disable. If enabled, when the Directory Dialing
Mailbox detects incoming fax CNG tone, it routes the call to the fax extension specified
in 8004 - Fax Extension.
- See Fax Detection on page 86 for more.
✔
By default, Fax Detection is disabled (N).
To allow the Directory Dialing Mailbox caller to dial 0 for other options or # to return to the
Automated Attendant:
8006 - IntraMail Routing Mailboxes: Next Call Routing Mailbox on page 232.
9.1
- Assign a Next Call Routing Mailbox (000-015) to the Directory Dialing Mailbox.
- To remove an assignment, press CLEAR.
- Once assigned, dialing # returns to the Automated Attendant. Dialing 0 follows the 0 action
of the Next Call Routing Mailbox.
✔
By default, there is no Next Call Routing Mailbox assigned.
To have an outside call be directly answered by the Directory Dialing Mailbox:
Make sure the active Answer Table uses the Call Routing Mailbox programmed as a Directory
10.1
Dialing Mailbox.
- See Answer Tables on page 30 for more.
✔
By default, Answer Table 1 routes to Routing Mailbox 000, with is a Call Routing Mailbox.
To allow callers to access Directory Dialing from a Dial Action Table action:
Make sure you have an action in the active Dial Action Table that is a GOTO to the Directory
11.1
Dialing Mailbox.
- See Dial Action Table on page 64 for more.
✔
By default, there are no actions assigned as a GOTO to a Directory Dialing Mailbox.
IntraMail System Guide