Table of Contents
Advertisement
Device Configuration
7.3Mapping Device Sessions
The 3494 Controller supports up to eight PU's. Up to four PU's may be configured on a
single Adapter Map/LSID Map screen. Each PU must be enabled in the PU Address
screen.
Below is a partial display showing the LSID Map located on the lower part of the screen.
Use the F2 key (next PU) to access the adapter map/ LSID map screen for the
remaining PU's.
Each PU is assigned an LSID Map. The letters in these fields represent the following:
Letter Represents
"T"
undetermined Twinax device mapped into its default PU session
"D"
primary display session
"d"
secondary display session
"P"
printer session
"E"
primary session of a device that allows file transfer
"e"
secondary session of a device that allows file transfer
"."
unassigned session
7.3.1Default Mapping
All Twinax devices are mapped by default to all the sessions in consecutive PUs.
4
Advertisement
Table of Contents
