Decision Data 3000 Series User Manual page 43

Controller LU Name
Controller CP Name
Default Mode Name
Logical Connection
Retry Counter
Logical Connection
Retry Interval
The name assigned to this controller at the AS/400 system
location. It should match the Remote Location Name defined
in the AS/400 R
EMOTE
attributes.
Valid characters are @,#,$,&, 0-9, A-Z (Upper case) up to 8
characters
The Control Point Name depends on whether the Advanced
Program to Program communication controller (APPC) and
the Remote Workstation Controller (RWS) are defined as the
same AS/400 system. If the APPC and the RWS are defined
from the same system, the CP name is one and the same, if
not , the CP name differs from the LU name
Valid characters are @,#,$,&, 0-9, A-Z (Upper case) up to 8
characters.
The name used when the Mode name of the AS/400 System
is not defined. The entry must be identical to a mode
description name in the AS/400.
The default mode name is QRMTWSC
Valid characters are @,#,$,&, 0-9, A-Z (Upper case) up to 8
characters.
The number of times the Controller should retry to establish
connection with the AS/400 system after connection failure.
Enter a value from 0 - 254, or 255 for UNLIMITED retries.
The default value is 10 retries]
The time lapse between retries to establish connection. Enter
a value in the range 0 (0 seconds) to 60 (ten minutes).
The default value is 6 (1 minute)
Network Information
W C
ORKSTATIONS ONTROLLER
3