Decision Data 3000 Series User Manual page 46

Network Information
AS/400 LU Name
AS/400 Network Name
Controller Network Name
Mode Name
6
The name of the Primary AS/400.
Valid characters are @,#,$,&, 0-9, A-Z (upper case). Up to 8
characters
Refer to the chapter 'Controller Line Configuration' under the
section 'AS/400 System Information' for tables showing the
AS/400 vs. the matching Controller parameters.
The name of the network to which the Primary AS/400 is
attached. If this field is not defined, the 'Default Network
Name' previously defined is used by the controller.
Valid characters are @,#,$,&, 0-9, A-Z (upper case). Up to 8
characters.
The name of the network to which the controller is
attached when it communicates with the AS/400. If this field
is not defined, the 'Default Network Name' previously defined,
is used by the controller.
Valid characters are @,#,$,&, 0-9, A-Z (upper case). Up to 8
characters.
The name must match the name defined in the Primary
AS/400.
Valid characters are @,#,$,&, 0-9, A-Z (upper case). Up to 8
characters.
The following parameters may either be entered here or,
included in the Open/Call/Answer commands (depending on
the Virtual circuit type chosen) entered from the
SYSTEM_REQUEST command entry line from the terminal
initiating communication with the Host.