Decision Data 3000 Series User Manual page 100

0097 to 0099 Host Support Error Codes
Refer to the following chart if the error code displayed is in the range from 0097 through
0099.
Note: When one of these codes is displayed, the required host support will not be available.
Error Code Description and Suggested Recovery
0097 Test Request Function Not Supported. Contact host system operator and
determine why the function is not supported.
0098 Undefined Hardware Error
To recover - press the Error Reset key.
0099 Host Support Not Currently Available
To recover - press the Error Reset key.
100000 to 101D00 X.25 Error Codes
When a keyboard entry error occurs while in X.25 Communication mode, a six-digit error
code between 100000 and 10FFFF is displayed. Error codes along with a short description
and suggested recovery action(s) are listed below:
For errors 100200 - check the system configuration. If the settings match, press the
ERROR RESET key, check options and repeat the operation. Refer to Host Access Section
for procedure on restarting communications. If this too fails, call your System Operator.
Error Description and Suggested Recovery
Code
Previous CALL command in progress. Wait until the previous call is complete, or an
100000
error code other than 100000 is displayed.
Virtual circuit already established. Wait for the virtual circuit to be detached before
100100
trying CALL/OPEN commands. It is possible to communicate over one virtual circuit
at a time.
ANSWER command entered for a PVC - Permanent Virtual Circuit`.
100200
CALL command entered for a PVC - Permanent Virtual Circuit
100300
Invalid logical channel ID.
100400
(Less than 3 characters long)
Invalid logical channel ID.
100500
(Not a hexadecimal value between 001 and FFF).
Invalid password. (More than 8 characters)
100600
Host Support Error Code Chart
Error Identification
A-13