Decision Data 3000 Series User Manual page 22

Setup Menu Options
Hardware Configuration
General
Host Connection
Controller Configuration
Network Information
Gateway
Enables the user to define the type of adapters
installed in the controller. Pressing F5 will
automatically configure the adapters according to
the current controller configuration. In the event
of a mismatch the user defined configuration and
the current adapters in the controller a CARD
SETUP ERROR message will be displayed when
rebooting the controller. If this occurs you should
reconfigure the adapter settings.
The initial screen allows you to define the
maximum number of sessions that can be
assigned to each PU. The latter value depends
on the OS/400 version you are working with.
Page forward to define the keyboard language,
The last screen allows you to configure the
Controller for Local Print by entering the port
number and station address to which the printer is
connected.
This option enables you to define the
communication lines to the AS/400.
The controller supports one serial communication
lines configured either as SDLC or X.25, and one
Ethernet or Token-Ring line. If communication
line to the host is either switched or leased,
select SDLC. If communicating over a
Packet_Switched Public Data Network, select
X.25
This option allows you to define the number of
PU's and the line type for each defined PU.
The controller consists of eight PU subsystems.
A corresponding APPC controller description
must be defined in the AS/400.
This option allows you to define the network
parameters required for communication between
the AS/400 system and the Controller.
This option is only available if a Token Ring or
Ethernet adapter is installed. It is used to define
Installation
9