Table of Contents
Advertisement
2.2.2Adapter Installation Procedure
To install the adapter:
1. Power off the controller and disconnect the power cord and all external cables.
2. Unscrew the two screws on the back panel slot that the adapter will be fitted into. Refer to
the above figure. It is not necessary to open the controller housing. Save the top screws
for reuse later.
3. Insert the adapter card by sliding it through the guide.
4. Secure the adapter with two screws already on the adapter panel. Refer to the above
figure.
5. Connect the power cord and other external cables that were disconnected at Step 1.
6. Power on the controller.
2.3Loading the Software
This section describes the front panel interfaces and the procedure for loading the setup
menus.
2.3.1Front Panel
The front panel provides status information and allows direct control of the controller
activities. This section explains the functions of the LEDs and panel keys. Note that the
front panel illustrated below, is of the 3494. The STK3494 front panel looks slightly different,
however, the functions are the same.
Panel keys
Diskette Activity
LCD Display
LEDs
The green diskette activity indicator on the front of the controller
Diskette Activity
Diskette Drive
Indicator
Installation
5
Advertisement
Table of Contents
