Table of Contents
Advertisement
5.3AS/400 System Configuration
The AS/400 S
YSTEM
AS/400 system information.
There are two sets of identical screens. System 1 screen is for the primary AS/400 system;
Systems 2/3/4 are for optional AS/400 Systems. The following information specifies the
names and connection numbers required for the controller to communicate with the host.
You must configure the section for the primary AS/400 system. Configuring sections for
additional AS/400s systems 1 to 3 allows you to connect the controller to other AS/400
systems.
Refer to your network subscription and match the parameters according to the following
table. Use the On-line Help and the parameter definitions provided in the table below.
AS/400 parameter
N
A
ETWORK
TTRIBUTES
N
A
ETWORK
TTRIBUTES
RWS C
- Remote network ID
ONTROLLER
The screen below illustrates an SDLC screen. This screen is given as an example since it
includes the most common parameters. Other parameters unique to specific line types or
attachments are listed following the SDLC parameters.
NOTE: If the values defined in the Network Information screen are default values, then after
defining the AS/400 LU Name, you may press enter and the other default values will
automatically be defined (this is the case, only for default values).
I
parameters enable you to define the Controller with the
NFORMATION
- Def. Local location
- Local network ID
Controller parameter
AS/400 LU name
AS/400 network name
3494 network name
Network Information
5
Advertisement
Table of Contents
