Decision Data 3000 Series User Manual page 107

Error Identification
09 Out of order - host not ready.
Wait. Then retry the operation. If the error recurs, report the problem to the network
service representative and the host system operator
0B Access to the host not allowed. Ensure that the correct network address for the host
system has been entered. Then retry the operation. If the problem persists, report the
error to the host system operator
0D Unrecognized host network address. Make sure that you entered the correct network
address for the host system. Then retry the operation. If the problem continues, report
the error to the host system operator
11 Error at the host system. Report the error to the host system operator. Include the
diagnostic code (dd).
13 Controller error. Look at the diagnostic code (dd). Retry the operation. If the error
recurs, report it to the person who planned the procedures.
15 Recognized Private Operating Agency (RPOA) out of order. Make sure that the correct
RPOA facility is selected or select a different RPOA. If the error recurs, report the
problem to the host system operator.
19 Reverse charging not subscribed Ensure that the correct host system address and the
correct number for the reverse charge has been entered. Retry the operation. If the
error recurs, report the problem to the host system operator
21 Incompatible destination. Ensure that the correct address has been entered. If the
address is correct, report the problem to the host system operator.
29 Fast select not subscribed. Ensure that call establishment is correct. This facility should
not be selected.
80-FF Call clearing originated at host system. Report the error to the host system operator.
DCE 19ccdd Cause Codes
An [19ccdd] Cause code is issued,when the data circuit-terminating equipment issues a
Reset indication packet after detecting an error.
[19] General error category.
[cc] Cause code.
[dd]
The cause codes listed are defined by CCITT Recommendation X.25. When any of these
codes are displayed, contact your supervisor. The job will have to be restarted. To restart
communications.
Cause Description and Suggested Recovery
Code
00 Reset originated at host system. Report the error to the host system
operator.
01 Out of order. Disconnected host system. Wait. Then retry the operation. If
the error recurs, report the problem to the network service representative
and the host system operator.
03 Error at the host system. Report the error to the host system operator.
Include the diagnostic code (dd).
A-20
Diagnostic code.