Table of Contents
Advertisement
3
Hardware and General Configuration
Begin your configuration by defining two functions: Types of adapters installed in the
controller and general controller parameters. General controller parameters include options
such as number of LSIDs per PU, keyboard language, and local printer. These functions
are defined via two separate options accessed from the Setup menu: Hardware
Configuration and General information.
This chapter describes these configuration procedures.
3.1Hardware Configuration
The controller adapter configuration is accomplished via the controller Hardware
Configuration option. To access it, choose 1. Hardware Configuration from the Setup
menu.
The following screen appears:
The adapter can be defined either automatically or manually.
Automatic adapter configuration is accomplished by pressing F5. This option automatically
reads and defines the adapters installed in your controller. Clearly this option is not used if
you are configuring a diskette for another controller.
To define the adapter manually, type the corresponding adapter type number below the slot.
ATTENTION!!!
In the event of a mismatch between the defined board configuration and the installed boards
on the controller, the message "CARD SETUP ERROR" will be displayed on every terminal
when the controller is rebooted. In response to this, reconfigure the adapter settings.
1
Advertisement
Table of Contents
