Analog Devices Linear LTM 4700 User Manual page 109

PMBus COMMAND DETAILS
STATUS_TEMPERATURE
The STATUS_TEMPERATURE commands returns one byte with status information on temperature. This is a paged
command and is related to the respective READ_TEMPERATURE_1 value.
STATUS_TEMPERATURE Message Contents:
BIT MEANING
7 External overtemperature fault.
6 External overtemperature warning.
5 Not supported (LTM4700 returns 0).
4 External undertemperature fault.
3:0 Not supported (LTM4700 returns 0).
.
The user is permitted to write a 1 to any bit in this command to clear a specific fault. This permits the user to clear
status by means other than using the CLEAR_FAULTS command.
This command has one data byte.
STATUS_CML
The STATUS_CML command returns one byte of status information on received commands, internal memory and logic.
STATUS_CML Message Contents:
BIT MEANING
7 Invalid or unsupported command received.
6 Invalid or unsupported data received.
5 Packet error check failed.
4 Memory fault detected.
3 Processor fault detected.
2 Reserved (LTM4700 returns 0).
1 Other communication fault.
0 Other memory or logic fault.
If either bit 3 or bit 4 of this command is set, a serious and significant internal error has been detected. Continued
operation of the part is not recommended if these bits are continuously set.
The user is permitted to write a 1 to any bit in this command to clear a specific fault. This permits the user to clear
status by means other than using the CLEAR_FAULTS command.
Any supported fault bit in this command will initiate an ALERT event.
This command has one data byte.
For more information www.analog.com
LTM4700
Rev. B
109