GE Centricity RA600 Service Manual page 82

Hardware Installation
1. Unpack optional RAM module(s) and retain packing material until installation is validated.
2. Power down CPU and disconnect power cord from the receptacle on the rear of the Dell 1400.
3. Open CPU case by removing the side access panel.
4. Remove the left-hand half of the workstation case.
l
Slide the rear padlock hasp toward the chassis center and press the release button on the
lower front of the bezel and remove the left side of the case. Refer to
l
For detailed removal instructions, refer to the Dell Online Documentation, Dell PowerEdge
System Documentation, Dell PowerEdge 1400, PowerEdge 1400 Installation and
Troubleshooting Guide, Checking Inside the Compuuter. The Dell Online Documentation
CD is shipped with each Dell 1400 CPU
Illustration 3-35:Side Access Panel Release.
IST 010 Installing Additional RAM Modules In CPU
Page 82
Illustration 3-35