GE Centricity RA600 Service Manual page 136

Software Configuration
4-1 Reinstalling or Updating your BarcoMed Drivers
To reinstall your current BarcoMed Display Driver or install a new version of the BarcoMed Display
Driver follow the steps below:
1. Right click on the desktop and select "Properties ". Select the "Settings" tab. Now select the
rectangle that represents the BarcoMed 3MP2FH Imaging Board whose driver you wish to
reinstall or update.
2. Click on the "Advanced" Button.
3. Select the "Adapter" tab and then click on the "Properties" button.
4. Select the "Driver" tab and then click on the "Update Date Driver" button. The "Upgrade
Device Driver" Wizard will start. Click "Next" to continue.
5. Select the radio button beside "Display a list of the known drivers for this device so that I can
choose a specific driver". Click "Next ".
6. In the "Hardware Type" page of the wizard, highlight "Display Adapters" and then click "Nex t".
7. In the "Select a Device Driver" page of the wizard click "Have Disk ". Insert your CORONIS
Driver Media or browse to the location of your driver and Click "OK ".
8. Select "BarcoMed 3MP2FH " in the "Select a Device Driver" window. Click "Nex t".
9. The "Start Device Driver Installation" dialog box will appear. Click "Nex t".
10. Windows will warn you that a digital signature was not found. Click "Yes" to continue the
installation.
11. When the drivers are installed, click "Finish" on the update driver wizard and click "Close" on
the properties page for the device. Reboot your system when asked, even if you are reinstalling
or updating the drivers for multiple BarcoMed 3MP2FH boards in yoursystem .
12. Boot normally and log on using an account with administrator privileges.
CNF 007 Configuring Barco 3MP2FH Video Driver
Page 136