Table of Contents
Advertisement
Hardware Installation
1.
1. Unpack optional hard drive and mounting screws and retain packing material until
installation is validated.
2.
2. Configure the hard drive as SCSI drive 2 by placing a jumper plug across pins 5 & 6 on the
28-pin connector at the front of the drive. Refer to
Illustration 3-11:Hard Drive Jumper configuration
3.
Power down the processor and unplug the power cord.
IST 009 Optional Internal Hard Drive Connect & Configure
Illustration
Page 58
3-11, following.
Advertisement
Table of Contents
Troubleshooting
