Sw 004 (A+,A,B) Dome Video Board Driver Installation - GE Centricity RA600 Service Manual

Software Procedures
n

SW 004 (A+,A,B) Dome Video Board Driver Installation

Section 1: Introduction
This job card describes how to install the driver for the A+, A, and B monitor video board (Dome
Md2, Md4, Md5).
Section 2: Items Required
u
Centricity RA600 Tools CD-ROM
u
A VGA service monitor.
Section 3: Prerequisites
u
OS is loaded.
u
Video board switch settings are set correctly.
u
Video boards are properly installed in the workstation.
u
Video cables are properly connected.
Note:
Only the correct drivers will successfully install with a particular video board. Be sure the
correct board is installed before proceeding with the following procedure.
Section 4: Procedure
SW 004 (A+,A,B) Dome Video Board Driver Installation
Page 193